I recently installed a Chaimberlain garage door opener in a location that required three buttons inside the garage. They limit the buttons in software, so that each garage door opener can have only two at any given time!
After some tinkering, I discovered that the Chaimberlain buttons transmit their signal wirelessly these days, even when "wired" to the garage door opener... the wires only provide power. So...
I worked around the problem by placing a dab of solder on one of their security+ 3.0 buttons so that it is always "pressed." Then I wired up the three old school garage door momentary switches to send power to it. When pressed, they power up the Chaimberlain button, which then sends a wireless signal to open the door.
The ratgdo encoder is a precision sensor that tracks your garage door's physical state. It enables your ratgdo control board to detect the door's exact position and direction of travel in real time—whether it's fully open, closed, or anywhere in between.
I feel dumb implementing my own "sliding door open/closed/in-between" sensor with 2 cheap zigbee door sensors and some logic in Home AssistantMaybe call it "How I learned to stop worrying and love the garage door opener" or "HILTS-WALT-GDO" for that extra eye-rollingness.
I ended up purchasing a Matter device which physically presses the button on a factory remote [1]. Ridiculous that such a solution needs to exist.
[1] https://www.thirdreality.com/products/smart-garage-door-open...
What a mess. I regret letting the installer use this opener. I was hoping i could just figure out what the Android app, or my Tesla does, to open the door and replicate that. Turns out I cant.
TBQH I used myQ to link it to HomeKit and literally haven't once opened that app since. Sounds like I should keep that going if at all possible.
FYI, the openers built into cars are very adaptable - my work has old school DIP-switch security on the garage gates, and it learned that just fine.
It’s been great but I know I’m on borrowed time.
If the garage door breaks I’m 100% NOT replacing it with another chamberlain. Good job guys