Hacker News new | past | comments | ask | show | jobs | submit
Pro Tip: you don’t need to buy one of the very expensive official ratgdo devices, if you are adventurous and can solder. The software is free and for a few bucks and a little time in KiCad you can build yourself a PCB, solder on the ESP32 and some electronics, and you’re off and running.
Don't even necessarily need to solder: I upgraded my garage door with a Shelly relay, a reed switch, and ESPHome. Maybe the ratgdo devices are doing a bit more, I'm not familiar with them, but there's probably still much cheaper pre-built boards available that can do the same job.
On a chamberlain like this the ratgdo is able to give you partial open/close, light control, button feedback, etc. Have I ever needed to open my garage door to 48%? No, but I could.
My very first tech project was a relay board, raspberry pi, and learning python. Long before AI. It was very fun
Similar story for my detached garage on my first home.

I got a Raspberry Pi, added a camera, pointed the camera at my man door then added the following features

- Push notifications if garage door or man door were left open more than 10 minutes or opened between 10:00PM and 6:00AM

- Camera takes photos every second while the man door is opened or motion detected, uploaded to my NAS

- Door open/close control via buttons or voice command

Was a fun little project. I abandoned it when I moved to a house with door openers which run off the myQ app. I haven't had the ad issues OP has (yet) so I've not been motivated to rebuild a custom solution.